G Series Hydraulic Suction Scanning Screen Filter

Self-Cleaning, Line Powered Water Filters for Landscape and Turf Applications

Rain Bird’s G-Series Hydraulic Suction Scanning Screen Filter provides cost-effective, worry-free medium-flow filtered water to protect all types of irrigation system components. Powered by source line water pressure, the filter’s backwashing system produces a concentrated high
velocity and low volume reverse water flow to systematically clean the screen of any entrapped contaminants. Models are available as a filter
unit only, or as a filter assembly including bypass plumbing and valves for fast and easy installation on site.



Dirty water enters the inlet, where it enters the fine screen. Suspended solids accumulate on the inner surface of the fine screen, building up a filter layer which eventually restricts the filter and creates a pressure differential. Once the pressure differential reaches a preset level a rinse cycle is initiated by the Rain Bird supplied controller. The solids are removed from the fine screen using a concentrated backwashing method which aggressively sucks the accumulated dirt off the screen where it is carried to drain via the rinse valve. The dirt collector rotates while it moves linearly, ensuring the entire screen is cleaned in a single cycle. The process takes a matter of seconds, without interruption of system flow.

Monitoring and Controls

The standard Rain Bird automatic control system consists of a microprocessor-based controller, a differential pressure switch and a solenoid actuated flush valve. The differential pressure switch monitors inlet and outlet pressures and comes factory preset to 7 psi. When the pressure differential of 7 psi is exceeded, the rinse valve is activated by the system controller, and the rinse cycle begins. If timed cleaning cycles are utilized, the system will automatically default to a backwash based on differential pressure if a 7 psi differential pressure is reached before the next timed cleaning cycle. The Rain Bird automatic controls are available for 115 VAC and 230 VAC, 50 / 60 Hz (user configurable) single phase power.

Note: G-Series filters integrated with a Rain Bird Pump Station utilize 110 VAC solenoids.


Rain Bird G-Series filters are built for years of durable, trouble-free service. The housing and covers of standard filters are made from thick wall high-grade 304 stainless steel. 316 L sintered stainless and wedge wire screens are available to trap sand, silt, algae and other debris from clogging drip emitters, rotors, nozzles, and spray heads. All wetted components are constructed of either engineered plastics or corrosion resistant metals.



  • Flow rate: 200-600 gpm; higher flows available upon request
  • Material of construction:
    • Filter body: 304 stainless steel
    • Fine screen: 316L sintered stainless steel standard, wedge wire slotted screen for high algae applications is available
    • Optional bypass manifold: painted carbon steel
  • Filtration level
    • Mesh: 150, 200 standard, others optional
    • Micron: 100, 200 & 300 standard, others optional
  • Inlet/Outlet connections: 2” NPT, 3” & 4”flanged
  • Flush line: 2” NPT
  • Minimum operating pressure: 40 psi
  • Maximum operating pressure: 150 psi

Automatic Controller

  • Two stations plus master valve
  • Input voltage 115VAC, 50/60 Hz; 230 VAC optional
  • Rust-proof outdoor enclosure
  • Pressure differential, time, or manual backflush actuation
  • Dimensions: 9.5” height x 7.8” width x 4” depth

G-Series Filter Performance Data Table


Related Documents