You Are Here: Home > Landscape Irrigation > Products > Drip Control Zone Components > Medium Flow Control Zone Kits with PR Filter

Medium Flow Control Zone Kits with PR Filter

Control Zone Components

Shorter kits with only two components (valve plus pressure-regulating filter) mean that you can fit more Control Zone Kits in a valve box, saving time and money.

These PR Filter kits provide on/off control, filtration, and pressure regulation with only two parts; so there is less chance of leakage at the connections, both at installation and over the life of the system.



XCZ-100-PRF 
1" DV Valve with 1" PR Filter (Assembled)*


RBY-200SSMX 
200 Mesh Stainless Steel
Replacement Screen

*Available with BSP threads.

Operating Range

  • Flow: 3.0 to 15.0 GPM (11.4 to 56.8 l/m)
  • Inlet Pressure: 20 to 150 psi (1.4 to 10.3 bar)
  • Regulated Pressure: 40 psi (2.8 bar)
  • Filtration: 200 mesh (75 micron)

    Note: An in-line check valve is required if the kit is not at the highest point in the irritation system.

Pressure Loss Chart

In order to supply 40 psi (2.8 bars) outlet pressure, additional pressure is needed at the inlet since there is some pressure loss from water flowing through the kit. The amount of pressure loss depends on the flowrate.

The charts below list the minimum inlet pressure required to supply 40 psi (2.8 bars) of outlet pressure.

Minimum Inlet Pressure for 40 psi Outlet Pressure
Flow (gpm) Inlet pressure (psi)
3.0 42.9
5.0 44.1
8.0 46.9
10.0 48.5
15.0 55.5

Metric

Minimum Inlet Pressure for 2.1 bar Outlet Pressure
Flow l/m Inlet Pressure (bar)
11.4 3.0
18.9 3.0
30.3 3.2
37.9 3.3
56.8 3.8