Or simply highlight, cut and paste the text below into your document(s)...
EAGLE™ 1100 Rotor
Model Specifications
The full-circle sprinkler shall be a water-lubricated gear drive rotor capable of covering a ____ (units) radius at a base pressure of ____ (units) and a discharge rate of ____ (units). The rotor shall be installed with a number ____ nozzle that shall be ____ in color for ease of identification.
Rotation through 360° shall be 4 ½ minutes or less.
The sprinkler shall be fully serviceable from the top without requiring special tools. The internal assembly shall be retained in the case by a plastic snap ring. The Rock Screen and Valve Seat shall be serviceable from the top. The rotor shall have a bearing guide that allows water to flush around the riser stem as it pops up and seals against the riser when it is fully raised. The pop-up height shall be 4.25”. The retract spring shall be of stainless steel and of sufficient force for positive pop-down.
The nozzle housing cover of the rotor shall indicate the model, identify the installed nozzle and have an arrow to indicate the position of the nozzle, and shall provide a positive seal against debris when the rotor is not in operation. The housing shall be installed with an interchangeable color-coded nozzle. The nozzle shall be tested per ASAE S398.1 and be verified to deliver scheduling coefficient of 1.3 or less and a Christiansen coefficient of uniformity of 90% or greater at the specified spacing.
The rotor body shall be molded of engineering-grade plastic and shall have a double-wall construction female (NPT, BSP or ACME) bottom inlet.
The rotor internal is compatible with all 900 Series rotor cases.
The rotor case shall have a top diameter of 7” (17,78 cm) and an overall height of 13.4" (34,0 cm). The case shall have a 1.5" (3,8 cm) NPT, BSP or ACME threaded inlet.
The sprinkler shall be as manufactured by Rain Bird Corporation, Glendora, California, U.S.A.
Optional Feature—Electric Valve in Head (e.g., 1100E). The sprinkler shall have a 24 VAC 60-cycle solenoid actuated normally closed control valve in the base of the case. The rotor shall have a pressure regulator which is adjustable from the top using a small flat-blade screwdriver. The rotor shall have a top serviceable selector that allows the unit to be operated manually, in automatic mode or shut off entirely.
Optional Feature—Normally Open Hydraulic Valve in Head (e.g., 1100H). The sprinkler shall have a normally open hydraulic control valve in the base of the case.
Optional Feature—Stopamatic Valve-in-Head (e.g., 1100S). The sprinkler shall have a Stopamatic valve in the base of the case. The valve shall hold back at least 15' (4,6 m) of elevation.
EAGLE 1100 Specs