XCZ-075-PRF-BF
3/4" pre-assembled kit with Low Flow in-line valve and automatic Back Flush Filter

This compact, factory assembled two-piece kit combines the 3/4” Low Flow Valve with the 3/4" Pressure Regulating Back Flush Filter to save installation time. The Low Flow Valve is the only valve on the market that can effectively handle low flows (below 3 gpm (0,19 l/s)) without weeping. The Pressure Regulating Back Flush Filter is a 200 mesh (75 micron) automatic self-cleaning filter that includes a 30 psi (2,1 bars) pressure regulator. The Back Flush Filter should be used in municipal water applications only.

Click here to view the Low Flow Valve Interactive Demo.

Click here to view the Back Flush Filter Interactive Demo.

Specifications

• Flow: 0.2 to 5 GPM (0.01 to 0.32 l/s)
• Inlet Pressure: 20 to 120 psi (1,4 to 8,3 bar)
• Regulated Pressure: 30 psi (2,1 bar)
• Filtration: 200 mesh (75 micron)
• Connections: ¾” inlet and outlet
• Size: 10” (25.4 cm) overall length

Caution: An in-line check valve is required if the kit is not at the highest point in the irrigation system.

Pressure Loss Chart

In order to supply 30 psi (2,1 bars) outlet pressure, additional pressure is needed at the inlet since there is some pressure loss from water flowing through the kit. The amount of pressure loss depends on the flowrate. The charts below list the minimum inlet pressure required to supply 30 psi (2,1 bars) of outlet pressure.

Metric