You Are Here: Home > Agriculture > Products > Filtration > Centrifugal Sand Separator

Centrifugal Sand Separators

Remove contaminants to minimize required maintenance
and increase efficiency

Centrifugal Sand SeparatorPumping water from wells or other sources with excessive amounts of sand, silt, or other abrasive grit particles can lead to the premature degradation of irrigation system components. These contaminants can reduce the efficiency of the irrigation system equipment by plugging and clogging sprinklers, drip emitters, valves, and spray nozzles. Repairing these components costs time and money in replacement parts, downtime and productivity.

Rain Bird Centrifugal Sand Separators are designed to separate abrasive particles before they can enter the irrigation system, keeping equipment clean and clear of debris, which minimizes the amount of maintenance required and increases operational efficiency. These filters are designed and manufactured in the USA to exacting standards, providing many years of optimal performance.

Rain Bird centrifugal separators are designed for easy installation, minimal maintenance, and reliable operation. The separator removes sand and particles that are heavier than water (materials with a specific gravity of 2 or greater) before these particles can damage your system. Note: Silt, due to its mass (or lack thereof) would not be able to be filtered.

Features

  • No moving parts
  • 150 PSI carbon steel construction with threaded or flanged inlet/outlet connections
  • Polyester powder coated for long service life
  • Non-ASME code standard construction
    (ASME code construction available optionally)
  • Capacities of 4 to 8300 gpm.
  • Simple installation (no electrical required)
  • Efficient pre-filter to reduce sand load on downstream components.
  • Cost effective

Liquids and solids enter the unit and begin traveling in a circular flow. This centrifugal action throws heavier particulates towards the filter walls and eventually downward in a spiral motion to the separation chamber. The particulates collect in the separation chamber and are purged manually from the system. The filtered water is then drawn to the separator’s vortex and through the outlet.

An optional automatic purge controller and valve can be used on all applications to automate the purge process, which eliminates the need for manual flushing. Small vertical design separators may be wall mounted or supported by the system piping.

 

Models

Vertical Centrifugal Sand Separator (Carbon Steel - Powder Coated)

VCS-R5V: DWG PDF
VCS-R7V: DWG PDF
VCS-R10V: DWG PDF
VCS-R12V: DWG PDF
VCS-R15V: DWG PDF
VCS-R20V: DWG PDF
VCS-R25V: DWG PDF
VCS-R30V: DWG PDF
VCS-R40V: DWG PDF

Angled Centrifugal Sand Separator (Carbon Steel - Powder Coated)

ACS-R40LA: DWG PDF
ACS-R60LA: DWG PDF
ACS-R80LA: DWG PDF
ACS-R100LA: DWG PDF
ACS-R120LA: DWG PDF
ACS-R140LA: DWG PDF
ACS-R160LA: DWG PDF
ACS-R180LA: DWG PDF